5. Quality control ABL800 FLEX Operator's Manual
Quality control identification
Entering
information
with barcode
reader
To enter the information with the barcode reader, do the following:
Step Action
1.
Scan "Operator" from your ID-card.
If the name is included in the list of the analyzer's registered users, the
barcode will identify the person and fill in the name automatically.
Entering
information
manually
To enter information manually, do the following:
Step Action
1.
Highlight the item to be edited, using the arrow buttons.
Solution
and Lot
Are automatically detected and entered if only one quality
control system is used. Otherwise highlight the desired
solution from the screen and confirm with Enter.
If the same type of QUALICHECK+/AutoCheck+ solution
is used, then only the solution type will be identified.
Choose the specific slot from the screen.
2.
For manual QC measurements only: Enter the temperature
(default: 25 °C) on the keypad and confirm with Enter.
Mandatory entry is indicated by a
"
.
Continued on next page
5-8
To Next Page
Loading...
Need help?
General
