3. Installation and setup ABL800 FLEX Operator's Manual
Communications
Programs
The Communications Setup programs are described in this section.
Activate a button to enter the program.
Refer to Chapter 2, Communication Ports for the identification and location of a
serial RS232 interface connection (COM2) and a network (TCP/IP) RJ45 ethernet
connection.
This program allows you to connect the analyzer to the RADIANCE system.
RADIANCE
Communication
Setup
NOTICE: Connecting the analyzer to the RADIANCE system should be
performed by the RADIANCE administrator in your institution.
To enable communication with the RADIANCE system, do the following:
Step Action
1.
Touch and highlight the "Server address" box.
Type in the TCP/IP address of your RADIANCE PC, using the screen
keypad or keyboard.
2.
Touch and highlight the "Port" box. Type in port number, using the
keyboard.
Touch and highlight the "Password" box. Type in your RADIANCE
password, using the keyboard.
3.
Continued on next page
3-68
To Next Page
Loading...
Need help?
General
