ABL800 FLEX Operator's Manual 3. Installation and setup
Communications, Continued
RADIANCE
Communication
Setup
(continued)
Step Action
4.
Press the check button in the "Radiance Communication" box to
activate connection.
The Icon in the "Connection status" box indicates the state of the
RADIANCE connection. "Connected" indicates an established
connection to the RADIANCE system.
The
icon will indicate the established connection as well.
5.
The "Output queue" box shows the number of data queued up for
transfer. It will be sent to the RADIANCE system.
Otherwise clear the queue by activating the recycle bin icon.
Press Close to exit the screen.
6.
This program allows you to select the communication protocol for a connected
device.
To select the communication protocol, do the following:
LIS/HIS
Connection
Setup
Step Action
1.
Press Add on the screen.
The "Output queue" box shows the number of data queued up for
transfer. It will be sent to LIS/HIS.
Otherwise clear the queue by activating the recycle bin icon.
Continued on next page
3-69
To Next Page
Loading...
Need help?
General
