ABL800 FLEX Operator's Manual 9. Data management
Quality Control Log
Purpose
The Quality Control Log is a historical file of all quality control results
automatically saved in the Quality Control Log after a measurement.
Each quality control result is listed chronologically as an individual record.
Each result is identified as follows (use the left/right scroll bar to see the items):
Item Description
Time Date and time the measurement was performed.
QC# The ID number of a quality control measurement.
Slot Control solution slot as defined in setup.
Solution Control solution type as defined in setup.
Lot Lot number of the control solution.
Status
Indicates the status of the quality control measurement:
OK
a successful measurement
?
an error detected or a measured value
exceeded a control, statistical or measuring
range.
Interrupted
a measurement stopped by the operator
Aborted
a measurement stopped by the analyzer
most likely due to insufficient sample.
NOTICE: The columns displayed in the log and their positions can be changed.
Contact a qualified service technician.
The functions of the buttons available on the Quality Control Log screen are
described in this section.
Continued on next page
9-11
To Next Page
Loading...
Need help?
General
