Need help?Do you have a question about the Radionics D9112 and is the answer not in the manual?
General| Brand | Radionics |
|---|---|
| Model | D9112 |
| Category | Control Systems |
| Language | English |
Using D5200 Programmer or RAM III for panel programming.
General installation procedure and required documents.
Mounting the enclosure and premises wiring considerations.
Steps for mounting the assembly into the enclosure.
Procedure for connecting earth ground to terminal 10.
Charging battery, self-diagnostics, static discharge prevention, and wiring devices.
Instructions for installing system modules and relays.
Procedure for powering up the panel after installation.
Loading custom programs using D5200 Programmer or RAM III.
Performing functional tests of the panel and connected devices.
Details on the primary (AC) power circuit and transformer.
Information on secondary (DC) power supply and batteries.
Procedure for installing the battery and connecting leads.
Monitoring battery voltage and reporting low battery or missing conditions.
Explanation of float charge, load shed, and overcharge protection.
Three self-resetting thermal circuit breakers protect panel outputs.
System provides up to 1.4A combined power for all devices.
Formula for calculating available current for fire systems.
Procedure for installing D136 relays and wiring considerations.
Details on alarm power outputs, available power, and terminal 8 functions.
RJ31X jack installation for line seizure and phone cord connection.
Panel's phone line monitoring feature for voltage and current testing.
Panel entering communication failure after failed attempts.
Allows panel to transmit over a secondary phone line when primary fails.
Procedure for mounting, wiring, and connecting phone lines to the D928.
Using ZONEX bus with POPITs and D8125 POPEX module.
Procedure for mounting the D8125 module in the enclosure.
Wiring procedures for connecting D8125 to the panel.
Connecting POPITs to the D8125 POPEX module using data expansion loops.
Connecting data expansion loops to POPEX modules and POPITs.
Procedure for installing the D8128C module in an enclosure.
Procedure for mounting the D8128C module.
Procedure for wiring D8128C OctoPOPIT modules to the panel.
Procedure for installing D8129 modules in the enclosure.
Connecting D8129 modules to ZONEX terminals.
Procedure for installing D811 modules in the enclosure.
Connecting D811 modules to ZONEX terminals for relay numbers.
Procedure for connecting and disconnecting the programmer.
Messages for trouble at Command Center, panel failure, and parameter errors.
Table of symptoms, diagnosis, and remedies for communication failures.
Procedure for performing a Service Walk Test on POPITs.
Formula for calculating battery requirements for Central Station/Local Systems.
Formula for calculating battery requirements for Remote Station/Auxiliary Systems.
Details on voltage input, current requirements, and power outputs.
To Next Page
