RADLEY Random Orbit Sander - Assembly and Operating Procedures; Sanding Disc Installation and Removal; Sander ON;OFF Switch Functionality; Attaching the Dust Bag Assembly

11
5" Rno ri sne - Onr's Mna
ASSEMBLY AND OPERATING
NOTE: The drawings in the assembly and
operating section of this manual may dier
slightly from the tool you purchased.
INSTALLING A SANDING DISC


NOTES:
a) Place the sanding disc so the holes in the



loop pad.


ON/OFF SWITCH



CONNECTING THE DUST BAG ASSEMBLY TO
THE SANDER
1. Slide the dust bag connector (1) into the dust

NOTE: 

2. When the dust bag connector is pressed


bag onto the sander.
Fig.2