RADLEY Random Orbit Sander - Effective Sanding Techniques; Sander Operation Best Practices

13
5" Rno ri sne - Onr's Mna
ASSEMBLY AND OPERATING
SANDING



if possible.
WARNING: 


complete sanding disc surface is in contact

pressing on the left-hand side of the ON/



the random orbital motion of the sanding disc



Upon completion of the sanding operation, turn


disc comes to a complete stop before removing

WARNING:


this sanding procedure could result in a loose

CLEAN THE DUST BAG OFTEN



NOTE: Hold the sander with one
hand on the hand grip (1) on top of
the sander (Fig. 7). Be careful NOT to
cover the cooling vents (2) with your
hand. Covering the cooling vents could
cause the motor to be damaged by
overheating.
DO NOT FORCE THE SANDER.






remove too much material, making the surface uneven.



before continuing the sanding operation.
Fig. 6