Installation Chapter 5
RADWIN 2000 User Manual Release 2.6.40 5-28
Figure 5-24: Services and Rates dialog: Available rates
To choose a modulation rate:
1. Choose Adaptive or one of the available rates.
2. Click Evaluate to continue or click the TDM Jitter Buffer tab to set the TDM Jitter
Buffer (see next section).
The service is activated as show below:
You are returned to the Services and rates dialog of Figure 5-24.
Setting Monitored Hot Standby Mode
If you are not using Hot Standby Mode, you may skip this section.
To install and use the Hot Standby feature, see Chapter 12. The following procedure can be
used to switch links between primary and secondary or to disable the mode.
To Next Page
Loading...
