Installation Chapter 5
RADWIN 2000 User Manual Release 2.6.40 5-30
Figure 5-26: TDM Jitter Buffer Configuration
Note
• The receiver jitter buffer for each site can be enlarged,
thereby increasing system resistance to interference (the
larger the jitter buffer, the longer the interference period
that the system will overcome without TDM errors).
• You can also decrease the jitter buffer to decrease the sys-
tem delay.
• The jitter buffer can be configured between 2.0 and 16.0
ms.
• After setting the new value you must evaluate the expected
quality. During the evaluation the TBFR (TDM Block Failure
Ratio)bar is displayed. You select either Next, which per-
forms the change or Back to cancel the change. Notice that
the Jitter Buffer is configured per site.
To Next Page
Loading...
