Installation Chapter 5
RADWIN 2000 User Manual Release 2.6.40 5-32
Figure 5-28: Services and TDM delay set - link ready for evaluation
3. You may make any further changes to the Service Configuration or the Jitter
buffer. When you are satisfied, click the Evaluate.
The optimum transmission rate for the selected services is evaluated.
Following a short delay for processing, Back and Next are enabled.
4. Click Next to continue.
Step 7, TDM Clock Configuration
The following dialog is displayed:
Note
The transmission rates used by RADWIN 2000 are shown in Table 5-3
above.
To Next Page
Loading...
