Installation Chapter 5
RADWIN 2000 User Manual Release 2.6.40 5-33
Figure 5-29: TDM Parameters Configuration (1)
To configure TDM clock parameters:
1. For any individual port, click it. For the same parameters for all ports, click
the Select Maximum tag.
2. Click Configure. The following drop down list is displayed:
Note
• Select Maximum will select the maximum number of services that
were configured for the air interface for configuration
• Deselect All unconditionally deselects all of the services for configu-
ration
• Without selecting anything, right-clicking any port will cause the
appearance of the drop down list of Figure 5-30 below
To Next Page
Loading...
