Radwin 2000 Series - Page 181

Configuration with Telnet Chapter 8
RADWIN 2000 User Manual Release 2.6.40 8-42
Table 8-3: Telnet - Set immediate commands
Command Explanation
set ip <ipaddr> <subnetMask> <gateway>
Set the ODU IP address, subnet mask and gateway. The user must reset
the ODU after the command completion
set trap <index:1-10> <ipaddr> <port:0-
65535>
Set a specific trap from the traps table (e.g. set trap 3 192.168.1.101
162)
set readpw <oldpasswd> <passwd> Set the read access password (Read Community)
set writepw <oldpasswd> <passwd> Set the read-write access password (Read-Write Community)
set trappw <oldpasswd> <passwd> Set the trap Community string
set buzzer <mode:0=OFF,1 =ON> Toggle the buzzer mode (0 – off, 1 – on)
set tpc<power:Value between minimal Tx power,
and maximal Tx power>
Set the ODU Tx Power. If a wrong value is entered, both min and max
values shall be displayed in the error reply
set name <new name> Set the name of the link
set location <new location> Set the site name
set contact <new contact> Set the name of the location
set ethernet <port:MNG,LAN1,LAN2>
<mode:AUTO,10H,10F,100H,100F,DISABLE>
Set the mode and speed of each Ethernet port
reboot
Resets both the IDU and the ODU. The user is warned that the command
will reset the ODU. A new Telnet session to the ODU may be opened after
the reset is complete. (Watch the IDU LEDs.)
help Displays the available commands
Table 8-4: Telnet - Set commands requiring reset
Command Explanation
set <ssid> Set Link ID
set rate <index:1-7,adaptive> Set the rat. Index is to the table as appears in the Config Wizard
set bridge <mode:0=Bridging OFF,1= Bridging
ON >
Set the ODU bridge mode (0 – off, 1 – on)
set ratio <1-1000> N/A
set dual_tx_mode (mode: 1=MIMO, 2=Diversity) Set dual antenna mode to MIMO or Diversity
set preferred frequencies clear N/A
set preferred frequencies add <freq> N/A