Radwin 2000 Series - Page 180

Configuration with Telnet Chapter 8
RADWIN 2000 User Manual Release 2.6.40 8-41
Figure 8-25: Telnet session log on
A Read-Only Community string allows display only whereas a Read-Write Community string
allows display and set commands.
Supported Telnet commands are shown in Table 8-4. Note that some of the commands are
model-specific. For example, TDM commands will not apply to Ethernet only and PoE based
links.
Table 8-2: Telnet - Display commands
Command Explanation
display inventory
Displays ODU product name, Name, Location, hardware and software
revisions, uptime, MAC address, IDU product name, IDU software and
hardware revisions
display management Displays IP, Subnet, Gateway, Traps table
display link
Displays State, Link ID, Channel BW, RSS, TSL, Frequency/ACS, DFS,
Rate/ARA, Distance
display ethernet Displays Bridge Mode, Aging time, Port table (State, Status and action)
display ethernet_errors Display FCS errors for ODU/IDU Rx, IDU LAN1/LAN2
display tdm
Displays Clock Mode, Master Clock Mode, Current Clock, Quality, TDM
table (Line status, Error Blocks)
display ntp Displays Time, Server and Offset
display PM <interface:AIR,LAN1,LAN2,TDM1,
TDM2,...,TDM16> <interval:current,day,month>
Shows the performance monitor tables for each interface according to
user defined monitoring intervals
display bands Display available bands
display ratio N/A
display syncloss_thresh N/A