Configuration with Telnet Chapter 8
RADWIN 2000 User Manual Release 2.6.40 8-40
Figure 8-24: Alignment tone buzzer states
3. Click Off. The tone is disabled.
To restore the alignment tone buzzer:
1. Choose a site. The Configuration dialog box opens.
2. Click On to have the buzzer beep continuously or Auto to have the buzzer beep only
in install mode.
Configuration with Telnet
A Telnet terminal can be used to configure and monitor the RADWIN 2000.
To start a Telnet session, use telnet <ODU_IP>.
For example, if you run Telnet as follows,
telnet 192.168.1.101
you will be asked for a user name and password.
The Telnet log on user name is the password that you used to enter the RADWIN Manager
(for example, the default:
admin
). The Telnet password is the corresponding Community
string (default:
netman
).
To Next Page
Loading...
