First steps Chapter 4
RADWIN 2000 User Manual Release 2.6.40 4-9
First steps
At this point the main window of the RADWIN Manager should be displayed:
Figure 4-10: Opening RADWIN Manager window prior to installation - IDU-C
A detailed field by field description of the contents of the RADWIN Manager main window
may be found in Chapter 6.
The procedure required to make the link functional has three phases:
1. Link Installation - which we will detail below.
Note
For what follows, it is assumed that you have set the IP addresses of both
ODUs. For the purposes of illustration, we will use the following IP
addresses:
Our managing computer has its NIC set to IP address 192.168.1.100. The
log-on ODU is set to IP address 192.168.1.101 and the over-the-air ODU is
set to 192.168.1.102. The Subnet Mask for both sites is 255.255.255.0 and
the Default Gateway is left unset. We will maintain this arrangement
throughout the remainder of this manual.
Other defaults are shown in Table 4-3.
Note
The Dynamic Tx Ratio bar only appears for model RADWIN 2000 C
To Next Page
Loading...
