Installation Chapter 5
RADWIN 2000 User Manual Release 2.6.40 5-15
Figure 5-11: Antenna type change warning
3. Repeat the process for the second site.
4. At the same time you can set the Antenna Gain and Cable Loss.
The Tx Power (per radio) indicates the power of each radio inside the ODU and is
used for Link Budget Calculations. The Tx Power (System) shows the total transmis-
sion power of the ODU and is used to calculate the EIRP according to regulations.
If you choose to set the Antenna Gain and Cable Loss, you will receive the following
warning message:
Note
For RADWIN 2000 B Links:
These ODUs may be switched between the SFF embedded antenna and
external antennas. To this end, the Antenna Connection Type radio buttons
are always enabled:
Use the Integrated radio button to enable the embedded antenna.
Observe that the SFF embedded antenna functions as a dual antenna and
cannot be changed.
Note
To see the relationship between Tx Power (radio) and Tx Power (system),
note that so that if you double the power in
milliWatts (for two radios) then dBm will increase by .
To Next Page
Loading...
