Installation Chapter 5
RADWIN 2000 User Manual Release 2.6.40 5-16
Figure 5-12: Antenna parameters change warning
If inequality (*) above is violated, then the following warning window is displayed:
Figure 5-13: Tx Power Limits
The precise relationship between the items in inequality (*) and the window of
Figure 5-10 is as follows:
• Required Tx Power (per radio) will be adjusted down to the lesser of the value
entered and maxAvailableTxPower
• Tx Power (system) is maxAvailableTxPower + 3 (for 2 radios)
•Max EIRP is maxRegEIRP.
•EIRP is maxAvailableTx Power + Antenna Gain - Cable Loss
The table in Figure 5-13 only shows rates where the maximum Tx Power is the lim-
itation, rather than regulations. When you close the window of Figure 5-13, the
change you requested will not be honored, and you will need to try again.
Note
• The Max EIRP level will be automatically set according to the selected
band and regulation.
• The EIRP level is the sum of the System Tx Power and the Antenna
Gain minus the Cable Loss.
To Next Page
Loading...
