Rae PGM-7240 - Changing the Pump Speed

PROGRAMMING
- 68 -
4.7.11 Changing the Pump Speed
There are two pump speeds of approximately 600 cc/min
and 400 cc/min designated as “high” and “low,”
respectively.
1.
“Change Pump Speed?” is the eleventh sub-menu item
in the Monitor Setup menu.
2.
Press the [Y/+] key and the display shows the current
pump speed: “Pump = Low?”
3.
Press the [Y/+] key to accept the currently displayed
output option. Press [N/ ] to change to the other external
option: “Pump = High?” Press [MODE] to exit this
sub-menu and move to the next monitor setup sub-
menu.
4.
If there are any changes to the existing selection,
pressing the [Y/+] key the display will show “Save?”
Then, press the [Y/+] key to save the change or press
[N/ ] to go back to Step 2.
Note: This Function 
discontinued.