Wireless transmitter instruction
Specification
Model
Frequency
Mould
Battery
Channel
Channel
Channel
Choose
Right
Open
Stop
Close
Up tilt
/75%
Horizontal
position
/50%
Down tilt
/25%
Channel
Choose
Left
Channel
setting
[stop]+[up/open]
[stop]+[down/close]
Press 5 seconds, press [programming
button] to confirm, switch on touch
cotnrol.
Press 5 seconds, press [programming
button] to confirm, switch off touch
cotnrol.
Set remote control channel
Enter into programming
Choose channels
Press programming button for 3 sec-
onds,until LED light on.
Press[Channel Choose Left] (or [ Channel
Choose Right]) button to choose the
needed channel.
Send the current channel code
Confirmation
Press[Channel Setting] button on the
back of transmitter till the indicator
light of the motor sparkles.
Press[Setting] button again to confirm
the operation. The remote channel is
set.
Delete remote control channels
Enter into setting codes status
Delete remote control channels
Press[Setting]button 3 seconds to
indicate till the indicator light on.
Press[Setting] buttton again for 7 sec-
onds till the light off. Channel deleting
is completed.
4
Warranty
Series motor carry a three years warranty from the date of invoice.Factitious
damage and dismantle are exclusive of wattantly.
To Next Page
Need help?
General
