Rage MICRO WARBIRD Series - Pre-Flight Checklist and Binding; Essential Flight Checklist Items; Receiver Binding Process

9 / 12
IMPORTANT NOTE:
Although this section can be used as a quick start guide, we
strongly suggest that you read the entire manual before proceeding. This checklist is
NOT intended to replace the content included in this instruction manual.
- Always turn the transmitter on rst.
- Ensure the throttle control stick is at bottom position before connecting the battery.
- Fly the model (hand-launch or take off from a at/level surface).
- Land the model (on a at/level surface).
- Unplug the battery from ESC.
- Always turn off the transmitter last.
Flight Checklist
Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identier) code of a single specic transmitter. When a receiver
is bound to a transmitter, the receiver will only respond to that specic transmitter.
Binding Instructions
If you need to rebind for any reason, please follow the steps below.
1. Keep the transmitter switched OFF with the throttle stick at bottom position.
NOTICE:
Keep PASS switch at Partial or Full assist position.
NOTICE:
Make sure you keep the plane still in a calm, stable position when initializing
the PASS system.
2. Connect the battery to the plane, then turn on the transmitter within 5 seconds.
3.The receiver LED will ash for 3 to 8 seconds before binding automatically.
4. After the receiver LED stops ashing, the binding process is complete and you are
ready to y.
CAUTION:
Remember to use caution when ying near people and property!