17
Cordless brushless brush cutter with blade and trimmer head
parameter measure value
Model - RDP-SBAG20
Rated voltage V 20
Type of battery cells - Li-ion
Battery capacity Ah 4
Number of battery cells - 5
Charging time h 1
No-Load Blade Speed min
-1
7500
No-Load Spool Speed min
-1
5500
Max. Cutting width mm 300
Sound pressurе (Lp
A) K=3.0 dB dB 80.6
Sound Level (Lw
Ad) K=2.2 dB dB 96
Vibrations (a
h
), K=1.5 m/s
2
m/s
2
4.549
Charger
parameter measure value
Voltage V AC 230
Frequency Hz 50
Protection class - II
Store the battery only in
dry rooms with an ambient
temperature of +10°C to +30°C.
Place only charged
batteries in storage (charged at
least 40%).
Display elements page 6
1. Trigger switch
2. A safety locking button
3. Speed controller
4. Battery
5. Basic handle
6. Auxiliary handle
7. Safety guard
8. Head with knife and cord
9. Charger
1. GENERAL SAFETY INSTRUCTIONS.
Read all the instructions carefully.
Failure to follow the instructions below may result in electric shock, re and / or serious injury. Keep
these instructions in a safe place.
Safety.
The use of a cordless brush cutter for children is not permitted. In no case should the machine
be operated by children or persons unfamiliar with this operating manual. The age of the machine
operator may be limited by national law. When not in use, keep the machine out of the reach of
children.
This cordless brush cutter is not intended to be used by persons (including children) with mental,
sensory or mental disabilities, as well as by persons without su cient experience and / or knowledge,
unless they are under the immediate control of the responsible for the safety of their person, or being
taught by him how to use it.
Under no circumstances should you mow while other persons are in close proximity, especially
children or pets.
Before adjusting the machine, when cleaning it or leaving it unattended, even for a short while, stop it.
Do not use the cordless brush cutter in adverse weather conditions.
Do not use or expose the cordless brush cutter to rain. Protect yourself from electric shock. After
switching o , the cord continues to rotate inertia and can cause injury. Do not place your hands or
feet near or under rotating elements.
Carefully inspect the pre-treated area and remove stones, sticks, branches, bottles, wires and other
foreign objects.
Always check that the cord retaining bolt is loose and that the cord is not worn before use.
Always mow in daylight or in very good arti cial light.
On slopes, always be sure to tread steadily.
Always work smoothly, never go fast.
Never operate the machine if safety equipment is damaged or without safety components.
Working on rough terrain can be dangerous.
Do not cut on steep slopes with a slope of more than 20%.
To Next Page
Loading...
