EasyManua.ls Logo

Raider RD-GLM08 - PREPARATION AND ASSEMBLY; UNPACKING INSTRUCTIONS; SET-UP INSTRUCTIONS

Raider RD-GLM08
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
25
www.raider.bg
WARNING:
B.1 Read Operators Manual.
B.2 Keep Bystanders Away.
B.3 Pay more attention to the operators hands and feet to avoid injured.
B.4 The engine exhaust is harmful to your health.
Don’t use inside of house.
B.5 Petrol is highly ammable, avoid exploding,
Don’t incline.
B.6 Be care of heat.
B.7 When repairing, please pick up the spark plug, then repair it according to the operational
manual.
SECTION 3: UNPACKING INSTRUCTIONS
REMOVE UNIT FROM CARTON
(See Figure 3)
Cut tapes at carton and peel along top ap to open carton. Remove loose parts if included with
unit (i.e., owners manual, etc.) Remove packing material.
Take unit out of carton. Check carton thoroughly for loose parts.
DISCONNECT SPARK PLUG WIRE
Before setting up your lawn mower.disconnect the spark plug wire from the spark plug.and
ground it against the engine by attaching rubber boot to a bolt or metal clip to the groundling post
on the engine.See gure-4
SECTION 4: SET-UP INSTRUCTIONS
ITEMS REQUIRED FOR ASSEMBLY
Pair of pliers ( Not necessary but helpful).
Motor oil.
Fresh Gasoline.
IMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL in the engine. Be certain to service
engine with gasoline and oil instructed in the separated engine manual before operating your mower.
NOTE: Reference to right or left hand side of the mower is observed from the
operating position.
SET UP YOUR LAWN MOWER
Follow steps 1 through 3 to set up your lawn mower. LAWN MOWER WITH GRASS BAG CATHER
Setp 1 :Remove the grass bag from the
Step2: Unfold the upper handle . Press the spanner to x the upper handle and lower handle
together.

Related product manuals