17
•Do not overload your device. Only work within the power range indicated and do not modify the
controller settings on the motor. Do not use low-per formance machines for heavy work. Do not use
the device for purposes for which it is not in tended.
•Do not use the device near am mable liquids or gases. There is a risk of re or explosion if this
advice is not heeded.
•Never pick up or carry away the device when the motor is running.
•The machine must not be used at altitudes over 2000 m.
•Never leave the device unat tended at the workplace when it is ready for use.
Maintenance and storage:
During maintenance of the cut ting blades, be aware of the fact that even if the power sup ply is
switched o, the cutting blades can be set into motion. • Make sure that all nuts, bolts and
screws are properly tight ened, and that the device is in safe working order.
•Inspect the lawn mower for any damage.
•Have any necessary repairs car ried out on damaged parts.
•Do not try to repair the device by yourself unless you have pro fessional training. All work not
mentioned in these instructions may only be performed by au thorised service representatives
commissioned by us.
•Store the device in a dry place and out of reach of children.
•Handle your device with care. Keep the tools sharpened and clean in order to be able to work better
and safer. Follow the maintenance instructions.
•Wear safety gloves when re placing the cutting equipment.
•Replace worn or damaged parts in the interests of safety. When setting up the blades, take care
that your ngers do not become caught between the rotating blades and stationary parts of the
machine.
•Ensure that only replacement cutting tools approved by the manufacturer are used.
Electrical safety:
•Make sure that the mains volt age matches the details on the type plate.
•Avoid body contact with earthed parts (e.g. metal fences, metal posts).
•Keep the power cord away from the cutting tool when working. The cutting blades can damage the
power cord and lead to con tact with live parts.
•Do not use the power cord to pull the plug from the outlet. Pro tect the power cord from heat, oil and
sharp edges.
•Switch the device o and pull the mains plug out of the outlet if the power cord is damaged. If the
cord of this device is dam aged, it must be replaced by the manufacturer or their customer service or
by a similarly qual ied person in order to avoid hazards.
•Do not connect a damaged power cord to the power sup ply. Do not touch a damaged power cord
as long as it is con nected to the power supply. A damaged power cord can result in voltage-carrying
parts being touched.
Special safety instructions for battery-powered devices:
•Ensure that the device is switched o before inserting the rechargeable battery. Inserting a battery
into a power tool that is switched on can lead to acci dents.
•Only charge your batteries in doors since the charger is not designed for outdoor use. Dan ger of
electric shock.
•In order to minimise the risk of electric shock, pull the charger plug out of the outlet prior to cleaning
it.
•Do not expose the battery to direct sunlight for long periods and do not place it on a radia tor. Heat
damages the battery and there is a risk of explosion.
•If warm, allow the battery to cool before charging.
•Do not open the battery and avoid mechanical damage to the battery. There is a risk of a short
circuit and vapours may leak out, causing irritation to the respiratory tract. Seek fresh air and also
seek medical assis tance in case of complaints.
•Do not use non-rechargeable batteries. The device could be come damaged.
Correct handling of the charger
This device can be used by chil dren aged 8 years and up as well as individuals with reduced
physical, sensory or mental abil ities or a lack of experience and knowledge if they are super vised or
To Next Page
Loading...
