RAIN s.p.a.
via Kennedy 38/40
20023 Cerro Maggiore
ITALY (MI)
ENGLISH
Introduction
Thank you for selecting a Rain controller. Rain designers have combined
the simplicity of mechanical switches with the accuracy of digital electroni-
cs to give you a controller that is both easy to program and extremely ver-
satile. The Rain controller provides convenience and fl exibility, letting you
run a fully automatic, semi-automatic, or a manual watering program for
all your watering needs.
Please read this manual thoroughly before
you begin to program and use the controller.
Installing Batteries
Open the battery compartment on the back
and insert 2 x 1.5 volt AA batteries. Make
sure batteries are installed with correct pola-
rity as indicated in the compartment to avoid
possible damage to timer. Close the battery
compartment properly and fi rmly to avoid
battery oxidation.
Installation
Connect the controller to the electric valve
with the rapid wire connector. Program the
controller by following the instructions in this
manual.
To Next Page
Loading...
Need help?
General
