12
Programming the Basic Settings
In general, all basic settings for your electric bicycle are pre-set. If you happen to change tire sizes, during
service, for example, you can reset the tire circumference to ensure the precise function of your speedo -
meter. Furthermore, you can set the unit to display the speed, the strength of the recharge when triggering
one of the two brake levers and the arrangement of the main functions. This is done by
entering programming codes.
Turn on the programming mode
Simultaneously push and until the display shows “0000”. The fi rst zero blinks. Change the value
of the selection with or and confi rm with . Select the other digits in the same manner until the
desired program is displayed.
Code Description
2001 Select km/h or mph
2002 Regeneration/brake output (for magnetic switch) 0-40 (ideally 30-40)
2005 Tire circumference (millimeters)
2009 Flip Display Plus/Minus 0 = power left, 1 = power right
Code 2001 Code 2002
Select unit - km/h or mph. Select with
or and confi rm with .
Default value: 30: adapt with
and
. Confi rm with .
Code 2005 Code 2009
Set tire size (in mm) - Select digits
one after another with
or and
confi rm with
.
Current setting of main functions is
displayed. Flip = 0, assist toggle is
on
the right side of console; Flip = 1,
assist
toggle is on the left side of console.
Confi rm with
.
WARNING
Please do not use other programming codes without consulting your authorized dealer.
If you type the wrong code, please push key to exit programming mode.
BIO_Anleitung_OEM_DERBY_ENGLISCH.indd 12 13.05.11 18:25
To Next Page
