When the gear selector is moved to REVERSE and the
Front or Rear system is disabled, the EVIC/DID will
display the ⬙FRONT PARKSENSE OFF⬙ or ⬙REAR
PARKSENSE OFF⬙ message for five seconds, followed by
a car graphic with ⬙OFF⬙ in the corresponding side. This
car graphic will be displayed for as long as the vehicle is
in REVERSE.
NOTE: Arc alerts from the enabled ParkSense system,
will interrupt the five second messages, and the EVIC/
DID will display the car graphic with the corresponding
arcs and ⬙OFF⬙ message.
The Front or Rear ParkSense switch LED will be ON
when Front or Rear ParkSense is disabled or requires
service. The Front or Rear ParkSense switch LED will be
OFF when the Front or Rear system is enabled. If the
Front or Rear ParkSense switch is pushed, and the system
requires service, the Front or Rear ParkSense switch LED
will blink momentarily, and then the LED will be ON.
Service The ParkSense Park Assist System
During vehicle start up, when the ParkSense System has
detected a faulted condition, the instrument cluster will
actuate a single chime, once per ignition cycle, and it will
display the ⬙PARKSENSE UNAVAILABLE WIPE REAR
SENSORS⬙, ⬙PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS⬙,orthe⬙PARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED⬙ message for five seconds.
When the gear selector is moved to Reverse and the
system has detected a faulted condition, the Electronic
Vehicle Information Center (EVIC) or Driver Information
Display (DID) will display a ⬙PARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORS⬙, ⬙PARKSENSE UNAVAIL-
ABLE WIPE FRONT SENSORS⬙ or ⬙PARKSENSE UN-
AVAILABLE SERVICE REQUIRED⬙ pop up message for
five seconds. After five seconds, a car graphic will be
208 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
