When the shift lever is moved to REVERSE and the Front
or Rear system is disabled, the EVIC/DID will display
the #FRONT PARKSENSE OFF# or #REAR PARKSENSE
OFF# message for five seconds, followed by a car graphic
with #OFF# in the corresponding side. This car graphic
will be displayed for as long as the vehicle is in RE-
VERSE.
NOTE: Arc alerts from the enabled ParkSense® system,
will interrupt the five second messages, and the EVIC/
DID will display the car graphic with the corresponding
arcs and #OFF# message.
The Front or Rear ParkSense® switch LED will be ON
when Front or Rear ParkSense® is disabled or requires
service. The Front or Rear ParkSense® switch LED will be
OFF when the Front or Rear system is enabled. If the Front
or Rear ParkSense® switch is pressed, and the system
requires service, the Front or Rear ParkSense® switch LED
will blink momentarily, and then the LED will be ON.
Service The ParkSense® Park Assist System
During vehicle start up, when the ParkSense® System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display the #PARKSENSE UNAVAILABLE WIPE
REAR SENSORS#, #PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS#,orthe#PARKSENSE UNAVAIL-
ABLE SERVICE REQUIRED# message for five seconds.
When the shift lever is moved to Reverse and the system
has detected a faulted condition, the Electronic Vehicle
Information Center (EVIC) or Driver Information Display
(DID) will display a #PARKSENSE UNAVAILABLE WIPE
REAR SENSORS#, #PARKSENSE UNAVAILABLE WIPE
FRONT SENSORS# or #PARKSENSE UNAVAILABLE
SERVICE REQUIRED# pop up message for five seconds.
After five seconds, a car graphic will be displayed with
#UNAVAILABLE# at either the front or rear sensor loca-
tion depending on where the fault is detected. The
system will continue to provide arc alerts for the side that
206 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
