EasyManua.ls Logo

RAM 3500 2012 - Maintaining Your Vehicle; Engine Access and Components

RAM 3500 2012
116 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FREEING A STUCK VEHICLE
If your vehicle becomes stuck in mud, sand or snow, it can often be moved by
a rocking motion. Turn your steering wheel right and left to clear the area
around the front wheels. Then, move the shift lever back and forth between
REVERSE and DRIVE. Using minimal accelerator pedal pressure to maintain
the rocking motion, without spinning the wheels, is most effective.
Allow the engine to idle with the transmission shift lever in NEUTRAL for at
least one minute after every five rocking-motion cycles. This will minimize
overheating and reduce the risk of transmission failure during prolonged
efforts to free a stuck vehicle.
NOTE: If your vehicle is equipped with Electronic Stability Control (ESC) or
Traction Control
, turn the system off before attempting to “rock” the vehicle.
CAUTION!
Revving the engine or spinning the wheels too fast may lead to
transmission overheating and failure. It can also damage the tires. Do not
spin the wheels above 30 mph (48 km/h) while in gear (no transmission
shifting occurring).
WARNING!
Fast spinning tires can be dangerous. Forces generated by excessive
wheel speeds may cause tire damage or failure. A tire could explode and
injure someone. Do not spin your vehicle's wheels faster than 30 mph
(48 km/h) when you are stuck. Do not let anyone near a spinning wheel, no
matter what the speed.
WHAT TO DO IN EMERGENCIES
87

Table of Contents

Related product manuals