Need help?Do you have a question about the RAM Pi Series and is the answer not in the manual?
General| 4 Ohm Stereo Power | 250 W |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| Signal to Noise Ratio | > 100 dB |
| Signal-to-Noise Ratio | > 100 dB |
| Damping Factor | > 200 |
| Input Impedance | 10 kOhms Balanced |
| Input Sensitivity | 1.4 Vrms (+5 dBu) |
| Dimensions | 19” x 1.75” x 12.1” (483 x 44 x 307 mm) |
| Weight | 14 lbs (6.4 kg) |
| Total Harmonic Distortion | < 0.05 % |
| Protection | Thermal, Short Circuit, DC Offset |
| Power Supply | 110V - 240V, 50Hz - 60Hz |
Explains safety symbols like exclamation point and lightning bolt, indicating potential hazards.
Warns about electrical shock risks, advises against opening the unit, and emphasizes professional servicing.
Guides on setting the amplifier to DUAL mode and connecting speakers and signals for stereo operation.
Guides on setting the amplifier to BRIDGE mode, connecting speakers and signals for mono operation.
Provides instructions for performing a factory reset, cautioning about data loss.
Explains the PMS EVO™ system for monitoring and controlling power to ensure safe operation under various conditions.
Describes the ICL2™ system, which prevents clipping to protect speakers and maintain audio quality.
Details the SSP™ protection, which limits power output to prevent damage from incorrect loads or short circuits.
To Next Page
