RAM Pi Series - System Settings and Management; Amplifier Gain and Bridge Mode Settings; Factory Reset Procedure

Installation and
Operation
Instalación y
operación
11
4. User Input Setting Screen:
User ID Input Label: shows the name assigned by the user
User EQ Access Button (see 4.1)
In: Input Level VUmeter
GAIN IN: to change the input gain
DELAY: to change the input delay (ms)
MIUTE: to mute input
Rev: to change input polarity
4.1. User EQ Screen:
EQ Memory Name
EQ ON/OFF: to anable/disable User EQ
On/Off HP 1-6: to access to specific filter and enable/disable it
Type: to asign the filter type to the selected EQ
FREQ: to asign the frequency to the selected EQ
GAIN: to asign the gain to the selected EQ
Q: to asign the Q to the selected EQ
5. Amp Info & Screen Config: (top section)
OPER. TIME: shows the amp operation time
SN / MODEL: shows serial number and model of the amp
HW / FW: shows the hardware and firmware versions
BACKLIGHT DIMMER: to change the screen brightness
AUTO OFF: to automatically tuen off the screen (selectable time)
AUTO LOCK: to automatically lock the screen after 60s
5.1. SNAPSHOT Tab:
Snapshot: shows the name of current Snapshot (if loaded one)
RECALL FROM LIB: to recall a Snapshot saved in the library
SAVE TO LIB: to save current amp setup to a Snapshot
DELETE SNAPSHOT MEM: to remove a library Snapshot