ST (Stereo)
When this is on, it indicates the radio station is transmit-
ting.
Searching for Stations In Automatic Mode
When you push
or for less than two seconds, the
radio will search for the next valid station. While the
radio is searching for the new station, the display will
show ⬙SEEKING⬙. When the search is complete, the
display will show the tuned frequency band and
station in the format ⬙F1 106.9⬙ or, if the station was
previously stored in memory, the display will show
the channel where it is stored and the tuned station.
Searching for Stations In Manual Mode
Pushing
or for more than two seconds displays
the selected radio station frequency. Each time a
button is pushed, the radio station frequency is in-
creased or decreased according to the default search
pattern for the selected band (100 kHz for FM and 10k
Hz for AM). When the search button is pushed and
held, the radio station frequency will continue to be
increased or decreased. If the buttons are not pushed
for five seconds, the display will show the message
⬙AUTO⬙ and manual search mode will be canceled.
When the search is complete, the display will show the
tuned band and station in the format ⬙F1 106.9⬙,or,if
the station found was previously stored in memory,
the display will show the channel where it is stored
and the tuned station.
Mute/Pause
Pushing this button mutes the sound. The display will
switch between ⬙MUTE ON⬙ and the previous display
(3 seconds).
Pushing the button again restores the audio without
changing the original volume setting. The display will
show ⬙MUTE OFF⬙ for three seconds, and then return to
the previous display mode.
158 UNDERSTANDING YOUR INSTRUMENT PANEL
To Next Page
Loading...
