1 - Main switch.
2 - Power cord to connect mains.
3 - Negative regulated voltage indicator.
4 - Positive regulated voltage indicator.
5 - 9 pins female sub D power output to be connected to the rear sub D 9 on the RP500 rear panel.
IMPORTANT
Warning !
The RP500 power supply mains connector has three wires (2 poles + earth). Earth should imperatively be connected to
mains earth.
Never use this equipement without proper grounding.
Check quality of grounding.
Should noise or hum occurs when connected to other equipments, never disconnect grounding, use insulating
transformer on mains.
Never open the case without disconnecting mains.
Avoid high temperature exposure.
Never expose the equipment to rain, snow or moisture.
Using RP500 headphone amplifier, listening to high level an result in permanent damage to ears.
The power supply and RP500 complie with :
EN60065, EN55013, EN55020, EN60555-2, and EN60555-3, according to 73/23/EEC, 89/336/EEC and 93/68/EEC.
POWER SUPPLY
RAmi
RP500
7
To Next Page
Loading...