Need help?Do you have a question about the RAM RP500 and is the answer not in the manual?
General| Brand | RAM |
|---|---|
| Model | RP500 |
| Category | Music Mixer |
| Language | English |
Crucial safety warnings and precautions for using the power supply and RP500 equipment.
Covers microphone input selection, line selection, and status indicators for MIC 1, Line 1, Line 2.
Input sensitivity, treble, mid, and bass tone controls with their respective ranges and neutral points.
Controls for sending audio to ANTENNA, PGM2/REC, and cueing input channels for monitoring.
Details the operation of the START key and its associated indicator for starting equipment.
Describes the LED peakmeter display and the VCA-driven long track fader for level control.
Dip switch for sensitivity adjustment and phantom power supply switch for microphone input.
Details XLR microphone input and RCA line inputs (Line 1 and Line 2) on the rear panel.
Explains the function of the Jack START remote control using an opto coupler.
Controls for muting, mono mode, input/output cueing, and volume for the control room output.
Controls for PGM2/Record output level and AFL listening key for monitoring and routing.
Controls for digital/analog antenna output level, and PFL key for monitoring.
Indicators and controls for sending Antenna/PGM2 to Studio output and talkback functionality.
Level control for the stereo balanced extension input used to add channels.
Controls for hybrid return level and routing to Antenna or PGM2/REC.
Controls for voice-over threshold, activation, and release for automatic program ducking.
Headphone socket and volume control for monitoring audio output.
Digital output peak indicators (left/right) and selection key for peakmeter source.
Controls for MASTER MIC sensitivity, routing, tone, input level, and activation.
Female XLR balanced sockets for Extension left and right inputs on the rear panel.
Cinch sockets for Hybrid return and Hybrid send connections.
Cinch sockets for analog MIX Antenna output (right and left).
Sub D 9 female connector for external power supply connection.
Headphone socket, also available on the front panel.
3-pin XLR AES/EBU digital output for 48KHz/24 bits.
Balanced XLR outputs for PGM2/REC signal (left and right).
Balanced XLR outputs for Antenna signal (left and right).
Cinch outputs for Control Room signal (left and right).
Cinch outputs for Studio signal with/without talkback from MASTER MIC.
USB audio socket for audio transfer to/from computer, with options for PGM2 output.
Controls for selecting Mic/Line input, XLR socket, and ON AIR light jack.
Dip switch to activate Control Room mute for all mics or only MASTER MIC.
Describes the USB socket, reset switch, and dip switches for channel and mode selection.
Explains the hex code format and byte structure for USB MIDI START commands.
Diagrams showing overall dimensions, rack unit size, and fitting cut-out dimensions.
Details the three available versions of the RP500 mixing desk based on features.
Wiring diagrams for ON AIR control with MASTER MIC and all microphones.
Wiring instructions for connecting the TEL150 telephone hybrid with two wiring options.
To Next Page