1 - Switch for microphone input selection. It takes over switch 3.
2 - Microphone input selection indicator.
3 - Line 1 / Line 2 selector, enable only when switch 1 is released
4 - Line 1 indicator
5 - Line 2 indicator
6 - Input sensibility pot control (range 28dB)
To set, input signal , and adjust to get 0dB on the display 15.
7 - High control pot. Range -12/+12dB, middle is neutral.
8 - Mid control pot. Range -12/+12dB, middle is neutral.
9 - Low control pot. Range -12/+12dB, middle is neutral.
10 - Send to hybrid control.
11 - Key to send stereo to ANTENNA, with associated indicator
12 - Key to send stereo to PGM2/REC, with associated indicator
13 - Cue key, and associated indicator. Sens audio to the display, and headphones even is fader16 is closed.
14 - Start and associated indicator. It requires two actions:
On one hand: First key 14 must be on and fader 16, slightly open. This allows START action
Either fader closed: press switch 14, and equipment starts on fader opening
Other fader 16 open around 0dB, pressing key 14 starts the equipment.
On the other hand:
Starting the equipment using H connector on the rear panel works only with Line 1 or Line 2 (switch 1
released)
If switch 1 is on, using microphone the start signal is sent to an internal bus, to the Y connector on the
output channel (see page 18) allowing to switch on the On Air signal
15 - Led peakmeter display.
16 - Long track fader driving a VCA (Voltage Control Amplifier).
INPUT CHANNEL 1: MIC1 / LINES 1 & 2 - FRONT PANEL
RAmi
RP500
9
To Next Page
Loading...