8
Fasten snaps on the main skin to the
sliding snaps along the top of the door
surrounds.
The sliding snaps will adjust to the proper
location for the snap on the main skin.
See Figure 10
Door Skin Replacement
Door skin replacements are designed to be
tight on the frame. This can make installation
difficult. Installation is best done when the
door skins have gotten warm/hot to the
touch.
Do not use tools during installation to avoid
damaging the fabric and seams.
Lay the door skin on a clean flat surface and
release the Velcro. Unzip the window. Insert
the front corner into the door skin moving to
the front/top corner and continue in a circle.
Pull bottom flaps up to meet Velcro.
See Figure 10
Reinstall upper half door to vehicle. Connect
the snap at the front bottom corner to the
door. Insert plastic strip along bottom of
upper half door to Belt Rail on exterior of
door.
Figure 11
Figure 10
1
2
3
4
Bottom Flaps
Fabric Installation
Page 8 of 9
To Next Page
Loading...
