Need help?Do you have a question about the Randall RG120 and is the answer not in the manual?
General| Type | Solid State |
|---|---|
| Power Output | 120 Watts |
| Channels | 2 |
| EQ Controls | 3-Band EQ |
| Effects Loop | Yes |
| Weight | 40 lbs |
| Outputs | 1 x 1/4" |
| Controls | Gain, Volume, Treble, Middle, Bass |
| Speaker | 1 x 12" |
| Inputs | 1 x 1/4" Instrument Input |
High gain input (+6dB) for most musical instruments, offering higher gain.
0dB input for instruments with very high output signals to prevent overload.
Master volume, channel volume, and gain boost for clean or distorted sounds.
Achieving a clean, nondistorted sound via master and channel volume controls.
Method for obtaining distortion and sustain using volume control combinations.
Circuitry for extended high range, suitable for demanding solo passages.
Master volume knob includes a pull switch to increase overall gain by 15dB.
Treble, middle, and bass controls for maximum tonal response adjustment.
Control for the amount of reverb introduced to the signal, activated by footswitch.
Controls for tremolo depth and speed, can be activated by footswitch.
Pilot light indicates power status; power/polarity switch for hum reduction.
Details on AC Line Cord, Circuit Breaker, AC Convenience Outlet, Footswitch, Speaker, Pre-Amp Output, and Effects Jacks.
Safety warnings regarding electrical shocks, ventilation, and general equipment care.
Detailed specifications on controls, circuitry, input signals, and noise ratio.
Randall RMS power output ratings for RG-120 and RG-300 models across impedances.
Information on test conditions, procedures, and equipment used for performance validation.
To Next Page
