Do you have a question about the Randall RT50H and is the answer not in the manual?
Power Output | 50 Watts |
---|---|
Tubes | Yes |
Effects Loop | Yes |
Preamp Tubes | 3 x 12AX7 |
Power Tubes | 2 x EL34 |
Footswitchable Channels | Yes |
Type | Tube |
Channels | 2 |
EQ | 3-Band (Bass, Mid, Treble) |
Speaker Output | 1 x 16 Ohm, 2 x 8 Ohm |
Dimensions | 10.5 x 9.5 inches |
Essential precautions for operating the amplifier safely and preventing damage.
Critical safety instructions applicable to all Randall electronic products.
Explains symbols for lightning flash and risk of electric shock.
Precautionary warning against exposing the unit to rain or moisture.
Control for selecting between three channels or bypass mode, programmable via MIDI.
Controls the output level for each of the two channels.
Adds low-end EQ to enhance guitar tone.
Adds hi-end EQ for sparkle and clarity to guitar tone.
Allows for biasing power tubes for optimal performance and tube longevity.
Protects power tubes by putting the amp in standby mode.
The main AC power switch to turn the unit on or off.
Allows operation at different AC voltage settings (100-230V).
Connects to MIDI preamps for signal routing and control.
Sets the correct impedance for connected speaker cabinets.
Connects the preamp signal to Channel 1 for mono or stereo operation.
Selects between 100W stereo or 50W per channel mono switching modes.
Connects to internal or external speakers, must be used for extension outputs.
Connects to additional external speaker cabinets.
Instructions on using a voltmeter to adjust the tube bias.
Recommended bias readings for various tube types.
Details on fast-blow fuses for tube protection and LED indicators.
Explains Ohm's Law in relation to bias measurements.
How to use MIDI to select channels on the RT2/50 with a preamp.
Step-by-step guide to programming channels via MIDI.
Instructions for programming the optional RF4 MIDI footswitch.
Phone number and email address for Randall customer support.