DESCRIPTION AND OPERATION
4.78 RANGE ROVER
AUTOMATIC HEADLAMP LEVELLING
DESCRIPTION
General
Automatic headlamp levelling is only fitted to vehicles with bi-xenon headlamps. The system
adjusts the vertical positioning of the headlamps to provide optimum headlamp beam
position for maximum driving visibility and preventing glare to oncoming drivers.
WARNING: The bi-xenon headlamp system generates up to 28000 volts and contact
with this voltage could lead to fatality. Ensure the headlamps are switched off before
working on the system.
The system is controlled by the headlamp levelling ECU, which is located at the base of the
LH 'A' post. The ECU receives information from the front and rear height sensors and the
ABS ECU to maintain the headlamps in the optimum vertical position.
For more information on automatic headlamp levelling, refer to the Lighting section of the
System Description and Operation Workshop Manual.
OPERATION
Power Distribution
Feed from the positive battery terminal (C0192) is supplied to fusible link 4 and fuse 53 of
the passenger compartment fuse box (C0632) on an R wire. Fusible link 4 (C0590) provides
a constant battery feed to the Light Check Module (LCM) (C2039) on an R wire.
Fuse 53 (C0583) provides a constant battery feed to the ignition switch (C0099 on Td6
vehicles, C0028 on V8 vehicles) on an R wire. When the ignition switch is turned to the
'auxiliary' position, current flows across the switch (C0099 on Td6 vehicles, C0028 on V8
vehicles) to fuse 9 of the passenger compartment fuse box (C0585) on a PB wire. Fuse 9
(C0587) provides an auxiliary ignition feed to the LCM (C2040) on a PY wire.
Light Check Module
When the engine is running, the Light Check Module (LCM) (C2040) provides a feed to the
headlamp levelling ECU (C1543) on a YR wire to initiate the automatic headlamp levelling
function.
The LCM (C2040) also monitors the condition of the brake pedal switch (C0075) by
providing a feed on a UR wire. This feed allows the headlamp levelling ECU to register when
the vehicle is about to decelerate and adjust the vertical position of the headlamps
accordingly.
For more information on the brake pedal switch, refer to the Brake and Reverse Lamps
section of this manual.
+ BRAKE AND REVERSE LAMPS.