DESCRIPTION AND OPERATION
4.80 RANGE ROVER
FOG LAMPS
DESCRIPTION
General
Operation of both the front and rear fog lamps is controlled by the Light Check Module
(LCM). The front fog lamps are only active when the ignition switch is in the 'ignition' position
and the fascia mounted rotary lighting switch is in the side or headlamp position.
When the lighting switch is in the side lamp position, the rear fog lamps will only operate if
the front fog lamps are operational. If the lighting switch is in the headlamp position, the rear
fog lamps can be switched on separately from the front fog lamps.
For more information on fog lamp operation, refer to the Lighting section of the System
Description and Operation Workshop Manual.
OPERATION
Front Fog Lamps
Power Distribution
Feed from the positive battery terminal (C0192) is supplied to fusible link 3 and fuse 53 of
the passenger compartment fuse box (C0632) on an R wire. Fusible link 3 (C0589) provides
a constant battery feed to the LCM (C0937) on an R wire.
Fuse 53 (C0583) provides a constant battery feed to the ignition switch (C0099 on Td6
vehicles, C0028 on V8 vehicles) on an R wire. When the ignition switch is turned to the
'auxiliary' position, current flows across the switch (C0099 on Td6 vehicles, C0028 on V8
vehicles) to fuse 9 of the passenger compartment fuse box (C0585) on a PB wire. Fuse 9
(C0587) provides an auxiliary ignition feed to the LCM (C2040) on a PY wire. The LCM
(C2039) is earthed on an N wire.
Light Check Module
The Light Check Module (LCM) (C2040) provides a feed to the lighting switch (C0041) on a
YW wire. When front fog lamps are selected, the switch contacts close momentarily. Current
flows across the switch to the LCM on an NB wire. Sensing this, the LCM powers the front
fog lamps.
The LCM (C0937) provides a feed to the RH front fog lamp (C0513) on a YN wire. The lamp
is earthed on an N wire. The LCM (C2039) also provides a feed to the LH front fog lamp
(C0514) on a YR wire. The lamp is earthed on an N wire.