DESCRIPTION AND OPERATION
4.82 RANGE ROVER
DIRECTION INDICATOR/HAZARD WARNING LAMPS
DESCRIPTION
General
Operation of the direction indicator lamps is controlled by the column mounted switch via the
Light Check Module (LCM). The direction indicator lamps operate when the ignition switch
is in either the 'auxiliary' or 'ignition' positions.
The front direction indicator lamps are located within the side lamp assemblies, outboard of
the headlamps. The rear direction indicator lamps are located within the tail lamp
assemblies. The rear direction indicators are mounted behind the brake lamp LED
assemblies. When the direction indicators are selected, a lens within the tail lamp directs the
light around the outer diameter of the brake lamp LED assembly.
The hazard warning switch is mounted on the centre of the fascia. When pressed, both sets
of direction indicator lamps operate simultaneously.
For more details on direction indicator and hazard warning lamp operation, refer to the
Lighting section of the System Description and Operation Workshop manual.
OPERATION
Power Distribution
Feed from the positive battery terminal (C0192) is supplied to fusible link 3, fusible link 4,
and fuse 53 of the passenger compartment fuse box (C0632) on an R wire. Fusible link 3
(C0589) and fusible link 4 (C0590) provide constant battery feeds to the Light Check Module
(LCM) (C0937 & C2039 respectively) on a pair of R wires.
Fuse 53 of the passenger compartment fuse box (C0583) provides a constant battery feed
to the ignition switch (C0099 on Td6 vehicles, C0028 on V8 vehicles) on an R wire. When
the ignition switch is turned to the 'auxiliary' position, current flows across the switch (C0099
on Td6 vehicles, C0028 on V8 vehicles) to fuse 9 of the passenger compartment fuse box
(C0585) on a PB wire. Fuse 9 (C0587) provides an auxiliary ignition feed to the Light Check
Module (LCM) (C2040) on a PY wire.
When the ignition switch is turned to the 'ignition' position, current flows across the switch
(C0099 on Td6 vehicles, C0028 on V8 vehicles) to fuse 4 of the passenger compartment
fuse box (C0585) on a G wire. Fuse 4 (C0587) provides an ignition feed to the LCM (C2040)
on a GS wire.
The LCM (C2039) is earthed on an N wire.