· 230 V (3~) 50 Hz
· 230 V (1~) 50Hz
The manufacturer's arrangement matches the first specification (that is: 400V, 3-phases, with
neutral); the others can be achieved following the provided wiring diagram.
The electric connection has to be made by interposing a general switch on the wall with fuses
having a capacity no lower than 25 A.
WARNING: While electrically connecting appliances working with 3-phase alternating current,
check the rotating direction of the pump motor.
WARNING: We highly recommend that the appliance is properly earthed.
The manufacturer assumes no liability for damage resulting from not observing this safety rule.
The manufacturer also assumes no liability for damage resulting from faulty electric connection.
USE
PRELIMINARY STEPS
Before starting the appliance, perform the following operations:
· Check that the filling and draining hoses supplied with the appliance are connected to the water
mains.
· The appliance is provided with a rinse aid dispenser and, on request, also with a detergent
dispenser, which are already set during the testing of the appliances by the manufacturer.
Connect the dispensers to their respective tanks, containing chemicals, which have necessarily to
be low-viscosity fluids; otherwise the dispensers may obstruct or break. Use only detergents
suitable for commercial dishwashers. Totally avoid foaming products.
· If present, check the right positioning of the detergent probe, because using the dispenser dry can
damage or break the device.
· Check the right positioning of the pump intake filter and of the surface filters.
· Check that the overflow pipe is in its right place.
· Lower the hood of the appliance and open the water cock.
English
17
To Next Page
Loading...