16
Levelling the Fridge-freezer and
Adjusting the Doors
Make sure that the appliance is on solid level ooring. If the
refrigerator is placed on a plinth, at, strong and re resistant
materials must be used.
This appliance has front adjustable feet, which can be used to
level the appliance.
Insert a suitable at screwdriver into the slots of the
adjustable feet. Turn the screwdriver clockwise to raise the
feet (Fig.4.9), and counter-clockwise to lower the feet
(Fig.4.10).
Levelling the Doors
The doors may require some alignment before connecting
the fridge-freezer to the electrical supply. This can be done by
adjusting the levelling feet (Fig.4.9 and Fig.4.10).
To raise the left-hand door turn the left-hand foot clockwise
until it is level (Fig.4.11).
To raise the right-hand door, turn the right-hand foot
clockwise until the it is level.
Fitting the Handles
The door handles x onto the mounting studs already tted
to each door (Fig.4.12).
Use the M3 grub screws and Allen key from the instruction kit
bag. Each handle will require 3 grub screws.
1. Place the handle rmly over the mounting studs.
2. Insert the grub screw into the hole located under each
handle stando bar.
3. Using the M3 Allen key, tighten the grub screw xing
the handle to the door.
4. Fix the grb screw cover.
Do not over-tighten the grub screw.
To Next Page
Loading...
