Electrical System
ELECTRICAL SYSTEM
FUSE PANEL INFORMATION
On some models, the fuse panel features plug-in type ATC fuses. The
fuses can be easily inspected and replaced. Z Comanche along with
certain Fisherman and Saltwater models have no replaceable fuses.
Circuits are reset as outlined in that models Electrical System section.
The Panel has a capacity of twelve to sixteen individual circuits. The
particular accessory(ies) they operate are shown on the decal on the right
side of the fuse panel or back side of the fuse panel cover.
To improve the performance of the batteries, turn the master switch or
breakers to the off position when the boat is not in use. Electronics,
stereos and other items that the boat may be equipped with, could have
a current draw even when those items are turned off. If you leave your
boat in the water, leave the breaker turned on in order for the automatic
bilge pump to have power. If conditions are such that the bilge pump is
operating frequently, it will be necessary to check the battery for its state
of charge and to charge as needed. On Saltwater models equipped with
digital switching, you may leave the main breaker and all cut off switches
turned to the off position while the boat is not in use. The auto bilge pump
on these models is connected directly to the battery and fused
independent of the main breaker.
52
Do not exceed recommended fuse sizes.
Always install proper rated fuse when
adding accessories to the fuse panel.
CAUTION
Inspect battery compartment(s) before
plugging in AC power to charger. Inspect
for loose wires, cracked battery, etc.
CAUTION
To Next Page
Loading...
