Need help?Do you have a question about the Ranger RCI-2900 and is the answer not in the manual?
General| Weight | 5.5 lbs |
|---|---|
| Input Voltage | 13.8 V DC |
| Channels | 40 |
| Antenna Impedance | 50 ohms |
| Frequency Range | 28.000 - 29.700 MHz |
| Modes | AM/FM/SSB |
| Tuning Steps | 10 kHz |
| Microphone Impedance | 600 ohms |
| Power Supply | 13.8V DC |
Connect the transceiver to a regulated 13.5 VDC negative ground source, ensuring stable voltage.
Connect a standard 50 ohm antenna using the rear panel SO-239 connector for optimal performance.
Controls the unit's power and audio output level, adjustable via a dual concentric knob.
Eliminates receiver background noise by adjusting a dual concentric control to the threshold of signal presence.
Calibrates the built-in SWR meter to measure antenna performance and match.
Fine-tunes frequency reception by ±500 Hz for clearer SSB/CW signals or optimized AM/FM signals.
Selects operating modes such as FM, AM, USB, LSB, CW, and Public Address.
Allows frequency selection in steps of 100Hz, 1KHz, 10KHz, 100KHz, or 1MHz.
Instructions for setting volume, squelch, RF gain, mode, and frequency for reception.
Steps to set frequency, microphone gain, and use the push-to-talk for transmitting.
Guide to manually selecting frequencies using MAN and SHF keys and the frequency selector.
Procedure to program upper and lower frequency limits for the scanner function.
Instructions for initiating and stopping program scanner frequency searches.
To Next Page
