36
GB
REPLACING THE INSERT STAPLER
The insert is replaced as follows. See figure 7:
1 Remove the power supply by pulling out the plug from the electric socket.
2 Remove the plate from the front of the base.
3 Move the trigger close to the anvil.
4 Pull the insert out carefully and remove it from the machine, being careful
not to damage the trigger mechanism.
5 Test the new insert before fitting it by manual stapling in a piece of paper.
6 Refit the insert in the machine being careful not to damage the trigger.
7 Mount the plate on the front of the base using the two screws. The
angled edge should be pointing downwards.
8 Check on the following before switching on the machine:
- That the insert is fitted straight and stable in the machine.
- That the trigger is undamaged and can be adjusted to the desired
position.
- That the magazine can be pressed down against the anvil.
TECHNICAL SPECIFICATION
Complete designation Rapid A100E
Width 130 mm
Length 270 mm
Height 150 mm
Weight 3.6 kg
Max. capacity 45 sheets (80g copying paper)
Max. stapling depth 85 mm
Staple type See front of magazine
No. of staples in magazine Strip staples
(66/6-8 approx. 210 staples)
(44/6-8 approx. 150 staples)
Equivalent noise level dB(A) at max. capacity and max. stapling force.
Example: See figure 8.
455 staples in 8 hours 70 dB(A)
Noise measurements carried out according to ISO 7779 with supplementary
proposal “Electrical staplers: Noise test code”.
The limit value 70 dB(A) equivalent noise level is a requirement in Germany
for the max. noise level in general premises of the type, shops, airport
check-in areas, receptions, and similar.
To Previous Page
Loading...
