19
4 Keep the magazine channel clean.
5 DO NOT oil or grease any parts.
6 Make sure the tool is not damaged. In case of damage, replace or
repair the tool prior to use.
CLEARING A JAMMED STAPLE ཹ
1 Press the magazine latch 🅔 to unlock it from the tacker body.
2 Slide the magazine 🅕 backwards.
3 Take out the loose staples from the magazine.
4 Use a pin with a sharp end to remove the jammed staple.
WARNING
Changes to the tool and technical modifi cations are not permit-
ted. This can lead to personal injury.
If the tool fails despite the care taken in manufacturing and
testing procedures, repair shall be carried out by an after-sales service
centre for Rapid tools.
DISPOSAL
EN Waste Electrical and Electronic Equipment (WEEE)
This symbol indicates that this device must not be treated as
unsorted municipal waste, but must be collected separately!
Dispose of the device via a collection point for the recycling of
waste electrical and electronic equipment within the EU and in other
European countries that operate separate collection systems for waste
electrical and electronic equipment. By disposing of the device in the
proper manner, you help to avoid possible hazards for the environment
and public health that could otherwise be caused by improper treat-
ment of waste equipment. The recycling of materials contributes to the
conservation of natural resources.
BTX10 Akkutacker
Übersetzung Der Original-
Bedienungsanleitung
EINLEITUNG
Dieses Werkzeug ist für das Tackern von Stoffen, Leder, Pappe, Papier
To Next Page
Loading...
