To Next PageTo Next Page
Need help?Do you have a question about the Rapid ESN114 and is the answer not in the manual?
Keep work area clean, avoid explosive atmospheres, keep children away.
Match plugs, avoid grounded surfaces, protect from water, care for cord, use outdoor/RCD cords.
Stay alert, use PPE, prevent unintentional start, remove keys, balance, dress properly, keep clear of moving parts.
Use correct tool, ensure switch works, disconnect power before adjustments, store safely, maintain tool, keep cutting tools sharp, use as intended, keep handles dry.
Use in dry area, 15-30°C temp, <60% humidity. Do not point at self, ensure workpiece contact, disconnect for jams, no electrical cables.
Turn off power, unplug, open magazine, load fasteners, close magazine securely.
Turn off power, unplug, open magazine, remove fasteners, close magazine.
Plug in, turn on, hold firmly, squeeze trigger, unplug and turn off after use.
Recommended wire area for extension cords based on length (up to 10m, up to 25m, over 25m).
Unplug, inspect screws, clean vents, clean tool, clean magazine channel, lubricate staple output area.
Unplug, hold tool upside down, squeeze latch, remove fasteners, close magazine.
If staple or brad jams, read maintenance section. Do not re-fire tool to clear jam.
Assume tool is loaded, do not aim at self/others, do not fire without workpiece contact, unplug for jams, be careful removing jams, no electrical cable fastening.
General| Model | ESN114 |
|---|---|
| Category | Staple Gun |
| Type | Electric |
| Staple Leg Length | 6 - 14 mm |
| Material | Plastic/Metal |
