Rapid7 Nexpose - System Management via LCD Menu; System Operations Menu; Advanced Functions Menu

To Previous Page

Security Console & Scan Engine Appliance Guide: Navigating the LCD Menu

Menu or Submenu Description

Restart Restart the Appliance. This operation may take a few minutes.

Ver: View the version of NeXpose currently installed on the Appliance.

Upd: View the date of the most recent NeXpose update.

SN: View the NeXpose serial number.

Send Logs Send diagnostics information and log les to Rapid7 Technical Support.

From Email Specify the sender’s e-mail address. Support will send any replies to this address.

Mail Relay (opt) Specify a mail relay server if direct Internet access is not available (optional setting).

Advanced Perform advanced NeXpose functions. Note: You can perform most of these functions by

using the NeXpose Web interface or the command prompt. See NeXpose Help.

Stop Nexpose Stop the NeXpose service without shutting down the Appliance.

Start Nexpose Start the NeXpose service.

Nexpose Port Change the port on which NeXpose service listens for https connections. The default value

is 3780.

Set Update Proxy Change the host name or IP address of the NeXpose update server. The default value is

updates.rapid7.com.

Shutdown Shut down the Appliance. This operation may take a few minutes.

Support View and send information required by Rapid7 Technical Support.

Update Now Download and install NeXpose updates immediately.

NeXpose Command Run a NeXpose command using a command prompt.

Reset All Reset the following settings to factory defaults if they were changed:

• 3780 for the NeXpose port

• updates.rapid7.com for the update server proxy

Note: In order for Reset All to take eect, you must restart the Appliance, not just NeXpose.

page 8 of 8