Rasonic RTP-B33TC - Operation Instructions; Initial Use and Boiling to Keep Warm

– 13 –
RTP-B33TC / RTP-W33S / RTP-B43TC / RTP-W43S 電熱水瓶 Thermo Pot
4. Operation Instructions
1. Before First Use
• Whentheunitisnew,itmayhavesmellduetothenewpacking.Thesmellwillgradually
disappear with time.
• Beforefirstuse,itisrecommendedtocleantheinnerpotbyboilingwater.Afterboiled,
press the ‘Pour’ key to dispense half of the hot water to clean the water dispense system
and then empty the inner pot.
2. Fill water
• Opentheupperlidandfillwaterintothethermopot.
• Bewarethewaterlevelmustnotexceedthefullwaterlevel.
• Afterfillingwater,closetheupperlidsecurelyuntilasnapsoundisheard.
3. Boil ➔ Keep Warm
• Plugoneendofthepowercordintothepowerconnectorofthethermopotandthe
other end into the power socket. The thermo pot will automatically enter the boiling
progress. The boiling indicator will be on. Once water has been boiled, the thermo pot
will switch to keep-warm mode automatically, the keep-warm indicator will be on. Keep
connecting to the power if you need to keep warm or use the electric pump or cup push
function.
• Attention:Waterdispensemaybenotsmoothwhenwaterisboilingorrightafterboiled.
4. Reboil ➔ Keep Warm
• Pleasemakesurewatermustbeabovetherefilllevelbeforereboiling,otherwisewater
should be refilled.
• Pressthe“Reboil”key,theboilingindicatorwillbeon.Afterreboiled,thethermopot
will switch to keep-warm mode automatically. The keep warm indicator will be on.
• Attention:Waterdispensemaybenotsmoothwhenwaterisboilingorrightafterboiled.
5. Cooling Function
• Coolingstatusmeanstheboilingandkeepwarmfunctionaredeactivated,waterwill
gradually cool down to room temperature. Connect the thermo pot with power when
using cooling function, so the electric pump and cup push function can be used.
• Afterwaterhas beenboiled, the keep warm indicatorwill be on.Press the “Boiling/
Cooling”key,theboiling/coolingindicatorwillbeon.Thethermopotwillswitchtothe
cooling status.
• Inordertoswitchfromthecoolingstatustotheboilingorkeepwarmstatus,pressthe
“Boiling/Cooling”keytostarttheboilingprocess.Theboilingindicatorwillbeon.After
water boiled, the thermo pot will switch to keep warm mode automatically and the keep
warm indicator will be on.
Shun Hing (37565(M)).indb 13 12年8月29日 下午3:53