RAT BARROW - Page 6

QUICK START GUIDE
STEERING:
STEP A To steer, place your hands on the handlebars well apart on the rubber grips
STEP B To turn left, push your right arm forward, this will pivot the RAT Barrow in the
middle. The further you push, the tighter the RAT Barrow will turn
STEP C Release pressure when turning, slowly and the Rat Barrow will return to the
straight position
STEP D To turn right push your left arm forward, this will pivot the RAT Barrow in the
middle. The further you push the tighter the rat Barrow will turn
KEY START:
STEP A Turn fuel on and check that the tank is full
STEP B Put your foot on the brake
STEP C Turn the key to RUN
STEP D Turn the key to start position. NOTE: Only 4 seconds at a time
STEP E This may take several times to prime fuel
NOTE: Only crank the engine for 4 seconds at a time, if the engine doesn’t start then wait for 15
second before performing step D again
PULL START (FLAT BATTERY):
STEP A Turn fuel on and check that the tank is full
STEP B Set the park brake to the ON position
STEP C Turn the key to RUN
STEP D Use pull start under seat
STEP E This may take several times to prime fuel
R
I
G
H
T
T
U
R
N
L
E
F
T
T
U
R
N
Pre-Operation check. Must be performed before RAT Barrow is used
1 2
3
4
CHECK OIL LEVEL If oil is
required, top up with Briggs and
Stratton SAE30 oil
FILL FUEL TANK 95 Octane is
recommended. Note using E85
may void warranty
TURN FUEL ON
TYRE Check Tyre Pressures:
Setting Front: 5-7 PSI or 35 to 48
kPa Rear: 5- PSI or 35 to 48 kPa
safety procedure
06
06
QUICK START GUIDE